Curt 13511 Hitch (Gen 1) Now with PICs!

[Rust Heap]

I just got done installing the Curt hitch on my 2001 XLE. It has 3500lb towing, 350lb tongue, 4000lb weight distributed.It looks good and was only $131 shipped! I broke a bolt during the removal of the recovery points, but extracted it with no damage to the nut-sert threads. Other than that, it was an easy install. I'll post pics when I get them.

FWIW my hitch did come in a box and required no "tweaking" to fit. Maybe it is just a gen II thing?
Edit:
You can see my 7 pin also, that was fun to wire up
Here are the pics. . . . .

[vva]

Please share how you wired it. Thanks

[kmahren]

Just installed the Curt 13511 on my 2003 XLE.... I had the towing (recovery) hooks already on my rear frame, so with a bit of PB, got them out fairly easily... Hitch installed without problems, no drilling or "tweeking" necessary, but visually, before actually installing, it looked like the muffler hanger would be in the way, but fortunately was not, tho the tow bar is right up against it. If I ever have to replace the rubber muffler hanger, will have to remove the tow bar.

Purchased the wiring kit for the sienna, which installed without a "hitch", but did bust a clip or two removing the panels...

All in all was relatively easy, looks good, and do not have any issues with it scraping the ground on bumps... in fact the tailpipe is lower to the ground than the hitch receiver... If your looking to add a trailer hitch to your sienna, the Curt seems to be a well made accessory.