Search Results for ‘bushing’

On my 2004 FWD sienna with 207K miles, I am thinking the steering is a little sloppy and there is a faint clunking sometimes. So went looking at everything and the tie tod ends seem solid, ball joints look good, wheel bearings seem ok. Looking at the rear bushing of the control arms I see the...

I have a 2007 Sienna. When parked and idling, or at very low speeds, there's been a rubbing/grinding/groaning noise from the front passenger wheel area. When turning slowly too. But when I start driving faster, it seems to go away. Mechanic looked at it and says it's a loose bushing and there's...

My 2000 Sienna developed chassis noise when change from R to D or D to R, and sudden accelerate. After jacking up the van, driver side lower control arm was found loose. So I order a bushing from eBay for around $22. There is a Youtube video on Sienna lower control arm bushing change, a press is...

I was under the van today taking a look at things when I noticed the one of the rear differential bushings (the front one) was shot. Apparently Toyota in their infinite wisdom, does not sell a separate bushing - you have to buy the whole assembly at the cost of ~$200. I'm going to try to...

I have a 2000 Sienna whose lower right control arm bushings are crumbling, causing quite a lot of rattling. I saw a very good post on this forum for a 2nd generation Sienna (2004) that says that replacement requires losening the engine mounts and rasing the engine slightly to access the control...

I am changing the brake pad for my 2006 Sienna LE and just find out driver side lower caliper pin is totally rusted. After 1 hour working on it, I got it out. The pin need to be replaced for sure but do I need to replace the bracket as well? I used wired brush to clean a bit for now. The rubber...

As the proud new owner of a 2011 SE and a long time lurker on the the board I am happy say I made my first mod. The SE has the best handling minivan suspension I have ever seen, as good (or better)as my wifes Bonneville SSEi. Having said that, I have always replaced the factory rubber sway bar...