Search Results for ‘caliper’

Hi, does anybody know where I can purchase new front brake caliper dust seals. Today upon inspection of the brakes I found that the front right brake caliper dust seal is ripped. Can I just buy the seal? I would really hate buying a whole new caliper. Thank you. Alex

What is the bolt torque requirements for the caliper attaching bolts and the caliper pins?

So I replaced my pads, and during greasing of the front caliper bolts, noticed that one of them had a bushing or washer that wouldn't stay in place - it had split (think these were the front bottom caliper bolts) When I look at rockauto - I don't see the bushing / washer that slides down the...

Brembo customized front 6 pots big caliper and rear 4 pots caliper with 405mm 2-Piece drilled disc rotor.

2005 Toyota Sienna XLE I had 2 new bearings pressed by a machine shop and after putting everything back together the left/driver side is not center to the caliper and is grinding at the inside top. I have taken the left side apart several times and can not figure out what the problem is. It...

Hello, I'm planning the front brake pad & rotor replacement of my 2011 Sienna LE FWD. If anyone knows, please let me know the torque spec below. 1. Caliper mounting bracket bolt 2. Guide pin bolt What I found on other web sites is 79 ft-lb & 25 ft-lb each for 2004 Sienna. But I'm not sure if...

Hi everyone, Only two places have ever worked on my van other than myself: Maplewood Toyota - Failed to notice obvious and severe uneven tire wear that nearly made the van unsafe to drive. I noticed the severe inside shoulder wear the night before taking it to them for a service but wanted to...

Weather is finally getting a little nicer here in Chicago so I'm thinking of painting my brake caliper, I used to do red on all my previous cars and they look clean and OK. Will red look ricey on the sienna SE? Other colors in mind are black or gun metal. Any recommendations? Thank you guys.

I'll have to service my rear brake soon and I am assuming that the parking brake mechanism is built in the caliper. Can you tell me if its the case, and if so how can I retract or in other word reset the piston in the caliper , Thanks guys !!

I am changing the brake pad for my 2006 Sienna LE and just find out driver side lower caliper pin is totally rusted. After 1 hour working on it, I got it out. The pin need to be replaced for sure but do I need to replace the bracket as well? I used wired brush to clean a bit for now. The rubber...

I have 4 caliper bracket clips, (DIFFERENT SIZES), that came with the caliper I purchased today. Rt Front. Need help determining the positioning of each clip on the bracket.

Left front brake rotor showing wear/grooves at top, but right side not. Going to replace rotor(s) and pads. I've never had to deal with sticking caliper, which I'm assuming right now is the problem on the left side. Silly question, then - what do you use to lubricate the sliders and pins? Mark...

I've tried the CRC Synthetic Brake Grease on my caliper pins and all it does is harden up over time. I just redid the front brakes again and the pins would barely move. This, inturn, wears the pads unevenly. This time I am using the following stuff: Rubber Grease Toyota p/n: 08887-01206 About...