Search Results for ‘insulation’

I've seen several posts about camper conversions but few on insulation in a 3rd generation sienna. It seems that whenever someone insulates a sienna (or a minivan) they rip out the rear heater/ac in the rear passenger side wall, I assume, to make room for the insulation and decrease open spaces...

My windshield washer nozzle broke off. I can't figure out how to safely remove the plastic clips holding the insulation to the under side of hood?

I have left over Raammat insulations and ensolite foam that I don't need anymore,pls make offer if interested.Local pick up only.

My 2006 CE suffers from a lot of road noise. There is a lot of coarse pavement in my area and at speeds over about 50 mph, the noise is transmitted from the tires into the body. It makes listening to the radio or carrying on a conversation difficult. When I drive onto a new patch of smooth...

Before Both doors were treated the same way. During 1 Layer of Raammat to the entire inner area. Speaker had a second layer of Raammat applied Interior holes were closed with wire mesh & covered with Raammat Plastic shield reapplied to door over Raammat Door panels were treated with 1...

This was the hardest part. Take your time. The A/C will loosen enough to get behind it. Before After with 1 layer of Raammat This is the trim panel. I did a very poor job. I used 1 layer of Ensolite glued over the factory insulation Each portion of the job resulted in sound reduction...

Before Passenger Doors Side Panels During 1 layer of Raammat The door itself was impossible (by me). I removed 31 nuts and still did not have access to the interior door panel During 1 layer of Ensolite glued to the Raammat After The original insulation pad glued to the Ensolite I did both...

Before During 1 layer of Raammat in Rear well During 1 Layer of Raammat to floor Completing with 1 layer of Ensolite glued to the Raammat Carpet

I started with the rear hatch area Before During: I layer Raammat to every spot I could reach. Advice! Use small pieces! Wire mesh all large openings, then cover with 1 layer Raammat Before After: 1 layer of Ensolite glued to interior panel over factory fabric. Not shown but very...