Search Results for ‘nut’

I decided, after 10 years in service on my 2004 FWD Sienna, to check the air pressure in my spare. So, lowered it using the hoist. It lowered OK and I measured 15psi, so topped it up to 60PSI. When raising the tire, though, the hoist would not go all the way up. I removed the hoist and...

Rear shock removal, stuck on nut I'm attempting to replace the rear struts on my 2003 Sienna. For the two nuts on the top, I was able to remove the first one. However, the second nut is very stubborn and I can't get it loose. I warped the top piece where I used a wrench to hold it in place and...

I have a 2006 Toyota Sienna LE. I need to replace a front axle and can't seem to find the correct socket to remove the axle nut. I have both a 30mm and a 32mm 12 point socket and the size appears to be something in between, maybe a 31 mm? All the posts from this forum and others say it's a 30...

Hi guys, Looking for another set of alloy wheels for my Sienna. Someone has a set of 2004 Camry rims for sale with new tires. I doubt I can use the OEM lug nuts on those rims. Do you know what size lug nuts would work for the Camry rims? Rims are 16in. Regards, JC.

I replaced both the cabin and engine air filters but when trying to close the engine filter compartment the nut that holds the screw in the front side just fell around the engine compartment and no where to be found. I had to go to the dealer for a quote on a break job and asked the parts guy...

08 sienna front axle nut torque? Hello new to the site, I have an 08 Sienna that needs front wheel bearings I was wondering if anyone new the torque spec for the axle nut. Also if anyone has any tips/tricks on making this job easier it would be appreciated. I'll be doing this with a buddy of...

We have a FWD 2011 XLE with a flat tire, fortunately at home. I've found the spare tire under the middle row, passenger side. The manual says to lower the tire via a bolt on the floor of the vehicle between the 1st and 2nd rows, on the right hand side. I've found a flap but there's just a bolt...

Hello all, I plan to buy a set of tools from craftsman that can be used on my 2012 Sienna AWD LE and 2000 Ford Taurus. Q> What is the lug nut size for 2012 Sienna AWD LE? Thank you

Quick question regarding 17" Alloy wheel lug nuts. I have an 06 Sienna XLE that has the corroding 17x6.5 alloys on it. I'm planning to make those my winter wheels and then run a set of 2011 Sienna 17x7 14 spoke wheels the rest of the year. When I did a test fitment, I noticed that my 06...

The dealer inspected my brakes and I had a private repair shop do he brakes for me 2 weeks later. The repair shop notified me that I was missing one lug nut. Since the dealer was the last one to work on the van, I asked them if they had it. They said no and the rims were not taken off since...

I just had the spare tire assembly replaced on my 2004 Toyota Sienna. The problem is that my original lug wrench does not fit the nut used to pull the tire up and down. The nut is a 5 point rather than the standard 6 point nut. Do any of you have a 5 pointed lug wrench? The repair shop doesn't...

I know that this has been discussed in the past, but I decided do some repeating because of what I found. I performed a brake job on my '09 with steel wheels two weeks ago. As it turned out, the rear pads the part store sold me were the wrong ones, so I put the old pads back on and waited until...

I have a 2010 Toyota Sienna Limited with the 17 inch factory / OEM aluminum wheels and I wanted to know what the torque specifications for the wheel lug nuts is? I have checked this website and found that 2009 torque specs are 76 ft/lbs but not sure if this also applies to the limited 17 inch...

Hi, all. new member here. Glad to find this site after siennaclub went down. I'm looking into do some work on my 04 sienna's front suspension. Wonder anyone knows the size of the axle nut size. I've tried the biggest socket 32mm I have and it still won't fit. TIA.