Search Results for ‘position’

2005 Toyota Sienna XLE Limited; driver's side seatbelt height adjuster is stuck in highest position (way too high for me). Is this fixable?

Hey Gents- Got an 04 Sienna. My front paasenger door (NOT the SLIDER) is closed and locked. After youtubing and searching here I still cant figure out how to get the door open to replace the actuator motor? Does a slim jim work? All othr doors work fine. If theres a link or a post onthis...

Hi everyone! I hope someone can advise me if this is at all possible or if I'll have to shop my van to get this done. My driver window is all the way down and I don't know how to raise it so I can replace the motor. I am comfortable with working on my van, as I have replaced the alternator...

I recently changed the thermostat and when I pulled out the old one I noticed the "jiggle Valve" (?) was not quite at the 12:00 o"clock position. It was at the 11:00 position. I noticed on someones pics that their thermostats was also at the 11. When I replace the new one I had the "jiggle "...

I have a 2002 Sienna. When a friend reclined the seat normally on one of the two second row seats, we couldn't get it to lock into any position other than fully reclined. It moves fine for it's normal range of motion, but it won't lock into any other position, just moves freely. Any ideas on...

HI Guys, I am having a problem with my Sienna. I can't get the starter to turn over with the key. No clicks. Nothing I've replace dthe starter, the battery, the starter relay, and the ignition switch. I've cleaned all the contacts. Nothing has helped. There is something bad between the key and...

Hi, Guys: I replaced my front brake pads and rotors a couple weeks ago. I found out the parking brake was not working when I put the Shift at N position. Is it normal for the second generation Sienna (06 XLE FWD)? Thanks, Than

I just got the oil pump off my 02 Sienna and will install a new one. I took the crankshaft sensor off the old pump. I believe the sensor is the original and has never been replaced. It is not failed either. The reason I am replacing the oil pump is because I got low oil pressure. Should I...

Somehow the passenger side power mirror got into a wrong position -- it is turned too much outward, about 120 degrees from its folded position. I have no idea how it got into that position. There are several drivers on this vehicle and nobody admits to the circumstances. But it would be...

How to remove sliding door panel with window stuck up NOTE: REPOSTED over to Gen II - http://www.siennachat.com/forum/185-problems-maintenance-repair/141490-how-remove-sliding-door-panel-window-stuck-up-position.html The Problem: The window is stuck in the up position but it sounds like the...

I have a 2012 Sienna SE FWD with 8 seats. I am trying to lock the second row seats in the forward-most position in order to maximize cargo space without having to remove the seats from the vehicle. When you pull the 2nd row seats forward in order to allow access to the third row, the 2nd row...

If you have the symptom, this TSB replaces the seat back assembly.

Some 2011 Sienna vehicles may exhibit a condition where the legs of the 3rd row power seat may overextend the strikers in the floor of the vehicle when moving the seat from the stowed position to the upright position. This can cause the power stow/latch function to become inoperative. Follow the...

I just got done changing out the timing belt on my 2003. It idles perfectly, runs great through the lower RPMs, but under hard acceleration it "spark knocks" and doesn't have near the power it did before. After a couple of days the check engine light came on. P0016 & P0018 are the codes. If I...

I have a question on the position of the drive lever when driving under normal flat roads. It just got to my attention a few days back. The last three years my wife and I have been placing the lever on the '4' position instead of the 'D' position. I am not sure if this was how the salesman...