Toyota Sienna Forum - siennachat.com banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 43 Results
  1. Problems, Maintenance, and Repair (Gen 2)
    Does anyone know where the breather vent is located on the Transfer Case? I am not referring to the weep hole on the right axle housing that is situated between two seals. The transfer case needs a way to equalize the air pressure inside the TC with the outside air. Otherwise gear oil can be...
  2. General Discussion (Gen 3)
    Probably a dumb question but does my 2015 LXE have tire pressure sensors? thanks???
  3. Problems, Maintenance, and Repair (Gen 1)
    Could someone please describe the location of the oil pressure sending unit on a 1999 Sienna? Thanks.
  4. Problems, Maintenance, and Repair (Gen 1)
    Greetings all! I'm a brand new Sienna owner, though I can happily say I don 15 years+ of toyota ownership (my other car is a stock 85' 4runner which I've decided to park as my weekend cruiser). Just got an incredible deal on a well cared for 02 Sienna, the price being sweetened in part...
  5. Problems, Maintenance, and Repair (Gen 2)
    Hi guys, I probably did something very stupid. I have a 2008 ce sienna. I Never worked on cars before. Last weekend, I took out the air cleaning chamber, battery, along with the air duct, the MAF sensor, etc in order to see the transmission. I was very careful so I am pretty sure I did not...
  6. Problems, Maintenance, and Repair (Gen 2)
    Hello to all! I am helping a family member with their 2005 Toyota Sienna XLE 3.3 V6, (120.000 miles) and i wanted to know how and where i can check the fuel pressure. In the last 6 months the van started doing all this weird things... *Running rough (rpm was low around 3-400) *Check engine...
  7. Problems, Maintenance, and Repair (Gen 2)
    I just had a new Jasper Transmission put in my 2005 Sienna XLE and I have a diagnostic code on my Actron CP9575 saying P0746 Pressure Control Solenoid A Performance or Stuck off. Is this related to work done during transmission R&R or something new? Appreciate input.
  8. General Discussion (Gen 3)
    Does anyone know how to reset the tpms light... I have located the button but what are the steps to resetting it...this is for a 2014 SE thanks for your help
  9. Problems, Maintenance, and Repair (Gen 2)
    Greetings, is there a way to understand which tire pressure monitor is acting up ? The light on dashboard is coming on and off and balancing the tire pressure is not fixing the problem. At this point I assume one of the sensors is going bad. Thank you and all the best, MaLi
  10. Problems, Maintenance, and Repair (Gen 1)
    My 02 Sienna got oil light so I replaced the oil pump. I had a oil pressure gauge on for a while. I can see the pressure improvement after the pump replacement. But I am not sure if the reading is good enough. Below is my reading. - Cold start: 90 psi - idle for 20 minutes (engine is hot): 20...
  11. Problems, Maintenance, and Repair (Gen 1)
    OK, so, I think I posted a lengthy explanation about my Sienna 1MZ FE engine problem but it has been awhile. I had to have the crankshaft ground .0010 and installed oversized bearings. Cleaned the engine, removed the heads and cleaned out all the sludge, lapped in the valves since I was that...
  12. Problems, Maintenance, and Repair (Gen 1)
    My tire pressure light occasionally comes on after driving on the highway (above 60+mph) for a few miles. I check my tire pressure regularly so I know it's at about 35psi. I have read the tire pressure sensor can go bad but I don't know which one it is. Can I tell that using the OBD? Is there a...
  13. Problems, Maintenance, and Repair (Gen 2)
    Hi, We have a 2004 Sienna AWD. After 10 years of frustration with RFTs, we recently switch to a new set of NRFTs from Goodyear. However, we are seeing that the tire pressure light will be ON every time after we drive the car for 10 minutes or so. Has anyone experienced the same? Thanks, Pai-Hung
  14. Problems, Maintenance, and Repair (Gen 1)
    02 Sienna, 111,000 miles, oil pressure light is on and CEL P1354 (vvt mulfunction), P0300 (random multi misfires). Removed the oil pressure switch and installed an oil pressure gauge. Here is the pressure test result. Engine start: ~80 psi Idle for 20 minutes: 20 psi At 2000-3000rpm: < 40 psi...
  15. Problems, Maintenance, and Repair (Gen 2)
    On my 2010 Sienna LE, I have had the low-tire pressure warning light come on a few times now, and there has been no issues with the tires or tire pressure. Each time I checked the pressure, it was fine, then I reset the light by pushing the black button on the left side of the steering wheel...
  16. Problems, Maintenance, and Repair (Gen 1)
    I have installed an oil pressure gauge on a Passat. Passat has a dummy port near the oil filter. Anyone ever installed one on 02 Sienna? Thanks..
  17. Problems, Maintenance, and Repair (Gen 1)
    Happy Holidays everyone! Background - Our 02 Sienna CE 114,700 miles had the oil pressure light on about 1-2 month ago. I did the following - - took off the oil pan and cleaned the clogged pickup screen. - new 5w-30 dino oil w/ a new mobile one filter - added a bottle of Auto-RX The...
  18. Problems, Maintenance, and Repair (Gen 2)
    I've done quite a bit of looking here and googlin, so will just ask to get though this mystery. I had crap canned my run flats long ago, due to the crappy design. When I did this, the store I had them replaced at 1st questioned if I wanted to do this, due to the rims most likely having a t/p...
  19. General Discussion (Gen 1)
    Hi, I am new here. Everytime when I search help for my sienna I end up reading post from siennachat, so I subscribed. The story of my Sienna is a little long so be patient and also hope this piece of info can help someone else. We bought this 2002 Sienna used (42,000 miles) in early 2005. The...
  20. Problems, Maintenance, and Repair (Gen 2)
    Our '06 Sienna with 82k miles just had it's Mich Defenders rotated and the tire pressure monitor is now illuminated. No monitor issues before rotation (done at Sam's Club). I run them at 39 psi and checked before holding down the reset button to extinguish the light. Light goes out for a...
1-20 of 43 Results
Top