Search Results for ‘put’

Hi Guys, I want to put some Ti2000 springs on my 2012 LE and I also want more support in the rear so I want install an air lift kit as well. I tried searching for similar questions but don't have any luck. I wanted to see if anyone has done this already or if you think it's possible. Thanks!

On my wife's '99 Sienna, I took the throttle body out in order to get to the IAC valve to really clean it. However, I took off the plate that has the flat spring and gray plastic cap in the hole. They fell out in the cleaning pan. My two main questions are: What position should the "shaft" with...

Where to put amplifier/crossovers? I just bought a set of component speakers (JL C5-650) and not sure where to put the crossovers. The door is probably most convenient, but not sure how to install it since there is that plastic sheet glued to the metal door frame, making it difficult to...

We've had our 2014 Sienna Limited for less than a month but I'm already trying to figure out how to mount three more switches on the dashboard. There are no unused blank switch plates on the Limited. The switches I plan to use are from other Toyota models sold in the U.S. or in other countries...

So I'm new to the whole minivan scene..... I'm used to to big trucks and cars with wheels and sound systems and ''pimped out stuff'' so we needed a good family car since our third kid just arrived so I sold my Lexus ES to buy a minivan (wasn't going to sell my 2 trucks) its for the wife mainly...

1999 Sienna Back Row Driver side Seat - Can't put back in Hello folks,Recently, I removed the 2 back row seats and the middle row seat.Now I can't put the driver side back row seat because the 2 levers at the front of the seat (beneath) did not "spring" back in place.The handle that is pulled...

Any help here would be much appreciated. Thanks, Andy

Hi All, I'm a first time Sienna owner. I just bought a 2014 XLE AWD Sienna. The car came with entune/navigation with a disclosure that has been noted here before about "additional hardware...blah blah required". When I bought the car, I asked the dealership to install XM for me. They said ok, we...

This morning,I replace one of my brake bulb.I did not start engine to check whether the new bulb work. I found when I depress the brake pedal,the brake light not work,and I can not put the selector lever from "P" to others. Now my car can not move. Yesterday in order to reset the maintenance...

Optilux by Hella H11 Xenon Yellow 55W 12v bulbs from amazon for $20. Installation was quick. got access to the fogs from underneath. Took out 2 screws per side. took me 5 minutes.

I'm about to purchase a set of winter tires on rims from Tire Rack and I'm debating whether or not to get the TPMS sensors installed. I don't mind ignoring a steady TPMS light on the dash, but if stays flashing or especially if every time I start the car it shows a warning on the information...

I'm thinking about putting 18 on SE, anyone done that? I sat in an airport shuttle with 17 and it is pretty plush so I was thinking to do the 18's. Thanks

Hey all, it's been awhile. Don't know if this has been mentioned here before. I was given a set of Highlander rims (16 inch) with brand new 225 70 R16 tires on them. I remember reading that the higlander wheels will fit my 2008 Sienna, but with that tire combination will i run into any problems...

Salsa Red Pearl w/ Bisque interior, security, mats/sills/, tow prep. Looking forward to picking it up on Tuesday!! We are replacing a 2002 Mazda MPV which we really liked but the transmission gave out and cost more to replace than vehicle was worth. It will take a while to get used to size...

My first post here - I just found this site from toyotanation. Glad I found you all. I have a 2001 Sienna LE. 91,900. Original rotors and 3rd set of pads. I bought Autozone Duralast Gold pads and Autozone rotors. Getting the driver side rotor off was difficult - needed lots of hammer whacks...