Toyota Sienna Forum - siennachat.com banner
Cancel

2001 Sienna Code P1349 (VVT)

4716 Views 3 Replies 2 Participants Last post by  rrhartjr, 
R
2001 Sienna, 140k miles is setting code P1349 (as well as misfire codes). I've taken out the solenoids and verified they activate on 12VDC.

Next step seems to be to find and clean the oil screen. Anyone know where I can find it? I can't seem to locate it or a good diagram of its location.

Thanks!
Reply
Save
Like
1 - 4 of 4 Posts
pjksr02
Did you check the Repair Manual, and do you mean the OCV screens?

http://www.siennachat.com/forum/65-...ienna-1st-gen-factory-rapair-manual-here.html
Reply
Save
Like
R
You are correct, I do mean the OCV screens. I did find the OCV in the manual, but can't seem to locate anything on the screens in the SFI section (which is where the OCV are).
Reply
Save
Like
R
Ok, I found them.. they are a 14mm bolt almost directly below the OCV themselves. When you take them out, be careful not to lose the washer!
Reply
Save
Like
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Toyota Sienna Forum - siennachat.com
SiennaChat is the forum community to discuss problems, maintenance, repairs, mods, projects, specs and all things Toyota Sienna.
Full Forum Listing
Explore Our Forums
General Discussion (Gen 3) Problems, Maintenance, and Repair (Gen 2) General Discussion (Gen 4) General Discussion (Gen 2) Problems, Maintenance, and Repair (Gen 3)
Top