50mm rear lift spacers for Gen2 sienna $40

2218 Views 4 Replies 3 Participants Last post by clavadoc, Nov 19, 2021

jengel

Discussion Starter · Apr 28, 2020 (Edited)

Selling a pair of rear lift spacers for the gen2 Sienna (also fit some Highlanders and Camrys) for $40. Items cost $77 plus shipping from Russia. Items are new and unused and received from the Russian seller tema4x4 on ebay. I went a different route and never used. These fit right in the top of the rear coil spring and raise your Sienna 50mm. The tough polyurethane spacers can be cut off to a shorter height if desired.

See less See more

Save

1 - 5 of 5 Posts

Craigrrr

· #2 · Apr 29, 2020

What route did you go with?

Save

jengel

Discussion Starter · #3 · Oct 27, 2020

Craigrrr said:
What route did you go with?

I went with honda odyssey springs in back. Gave about 3" lift. More than I wanted but when the van is fully loaded for a trip with the whole family, rear kitchen, roof box, and hitch 4x bike rack the loaded height is stock and no dragging the hitch rack on curb cuts. Awesome.

Save

Reactions: 1

jengel

Discussion Starter · #4 · Oct 27, 2020

Check here Craigrrr:

Lifting a Gen2 FWD XLE for camping and exploration

I've been reading all I can find on lifting our FWD Gen2 Sienna XLE a bit in an effort to improve the ground clearance and load carrying capability of the van to facilitate boondock camping and general outdoor exploration. We're not looking for rock-crawling, just the ability to better handle...

www.siennachat.com

Save

Reactions: 1

clavadoc

· #5 · Nov 19, 2021

Are these still available?

Save

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Lifting a Gen2 FWD XLE for camping and exploration

Top Contributors this Month