Toyota Sienna Forum - siennachat.com banner
1 - 9 of 9 Posts

Registered
Joined
61 Posts
Discussion Starter · #1 · (Edited)
yup, the XSE non-tech-pack doesn't have fog light in Canada
althought it doesn't have the fog light
the wires and connectors are already there
what you need is a fog light and a turning/light knob with fog switch

The Canadian XSE knob vs the US knob(?) with fog light and drl off
Hand Photograph White Camera accessory Product




3 screws to take over the wheel covers
Hood Automotive tire Automotive lighting Automotive design Automotive exterior




Its just 2 screws securing the knob, take it out and plugin the new knob

Plant Vehicle Car Speedometer Steering part





The fog light kit with harness and switch
only need the fog light for XSE


Automotive lighting Automotive tire Motor vehicle Electrical wiring Rim






The wire and connector found behind the bumper
just plug it into the fog light


Hand Automotive tire Gesture Finger Thumb

Hand Bicycle Bicycle tire Automotive tire Finger





Car Vehicle registration plate Vehicle Grille Window



Done, an easy upgrade for the Canadian XSE
 

Attachments

Registered
Joined
61 Posts
Discussion Starter · #9 ·
That's an awesome install you did! How did you access the fog lights location, did you go underneath it or by the wheel well? Do you have the link for the fog lights & the light knob? I just have a '22 LE & I looked under it & it got wiring for the fog lights, so im just wondering if it's the same case with my LE. Thanks & hoping for your help!馃檪馃憤馃徏
From the wheel well, just need to take off 2 clips and 2 screws and then you got plenty of room to get your hand in there
I bought everything on the chinese shopping web site Taobao and got it shipped to Canada
I couldn't find the knob on ebay or aliexpress
this is a similar fog light kit on ebay:
Fit 2021 2022 Toyota Sienna w/Wire Harness Switch Pair LED Fog Driving Light Set | eBay
 

Registered
Joined
61 Posts
Discussion Starter · #11 ·

Registered
Joined
61 Posts
Discussion Starter · #13 ·
Thanks for that. I found this which isn't exactly the same but I think should fit:
US $48.17 30%OFF | Auto Headlight Closing Handle Sensor Switch Fog Light Button For Toyota RAV4 2019-2022 84329-33060
this is exactly the one i have锛宯ice find
 

Registered
Joined
61 Posts
Discussion Starter · #17 ·
Just tried to do this over the weekend. How did you remove the turn signal switch? Other than the two screws, is there a clip or anything I need to push down to remove it?

I removed the two screws but it would not slide out. I tried pulling on it but did not want to pull too hard as I was nervous I might break something on my $40K six month old vehicle. Any advice?
might be this clip on the photo
Motorcycle Automotive tire Motor vehicle Automotive design Steering part
 

Registered
Joined
61 Posts
Discussion Starter · #24 ·
I tried again today. I pushed on the clip and pulled with my fingernails but the stalk still would not come off. I鈥檒l just have it done at the dealership. I was planning to have them install the fog lights anyway so I鈥檒l ask them to do the turn signal stalk as well. I couldn鈥檛 fit my hand in the side of the bumper like how you did to tighten the fog lights enough. Not enough room for my hands.

I can confirm P/N 84329-0R020 is the correct part number. However, i notice its a little different from OPs. Looks like OP has two options of fog light setting instead of one. I am curious, what does both those settings do?
here is a short video shown how to take off the knob

 

Registered
Joined
61 Posts
Discussion Starter · #32 ·
I was able to complete this mod this morning. Probably best mod to do for an LE. Thank you jays3l33t

Here are the part numbers:
LAMP ASSY FOG RH - 81210-08040
LAMP ASSY FOG LH - 81220-08040
TURN SIGNAL SWITCH - 84329-0R020

Total if buying OEM from an online Toyota Dealership website is under $300.00.
(y) (y) very nice
so the LE trim got the harness pre-wire as well?
 
1 - 9 of 9 Posts
Top