Toyota Sienna Forum - banner

The climate hose Tee's issue

710 Views 3 Replies 3 Participants Last post by  Craigrrr
As I posted a while back about a road trip in June coming back from a cross country trip I had one of the 2 tee's fall apart while on I-40 it was cool and rainy so I saw the mist right away from under the hood caught it in time had a tow to Moriarity NM. about 39 miles from where I pulled off the interstate. A shop repaired it for 300 bucks They used a brass pex fitting 3/4" and used screw type hose clamps for the job. I was good with that well still am. So today I figured I better do the other one that is left so I bought a brass tee 3/4" pex and 3 new screw clamps I think the cost was 12 bucks... LOL AS I removed one of the factory pinch / squeeze clamps I saw that one end was starting to crumble apart. I am glad I finally got around to it as I am getting ready to go on a fall trip. I am glad I did not wait as when I started to remove the pinch/ squeeze clamp OEM I could see the tee crumbling it was only a matter of time till it would leak. So the Moral of this story is DO NOT WAIT.. Change them both My 2008 XLE is alive !

Automotive fuel system Automotive tire Motor vehicle Car Automotive exterior

Motor vehicle Automotive air manifold Gas Wood Auto part

Automotive tire Motor vehicle Hood Automotive wheel system Auto part

Fluid Bicycle part Cylinder Gas Nickel
See less See more
  • Like
Reactions: 2
1 - 2 of 4 Posts
Thank you so much for this. Is there a difference in size between a 3/4” PEX and a regular barbed tee? I am totally doing this asap.
Not that I know of.
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.